www.sdlsuite.com Forum Index www.sdlsuite.com
Discussion of technical aspects of the SDL Component Suite
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

TnumIO2 error

 
Post new topic   Reply to topic    www.sdlsuite.com Forum Index -> GuiPack
View previous topic :: View next topic  
Author Message
kjskont



Joined: 03 Mar 2012
Posts: 10

PostPosted: Fri Aug 16, 2013 6:56 pm    Post subject: TnumIO2 error Reply with quote

TnumIO2.value do not return to zero when the property InputFormat is set to ITexp!
Place two TnumIO2 and two buttons on a form. Button1 is Up and Button2 is Down. The code in Button1 is just increasing TnumIO21.value and TnumIO22.value by 0.1. The down button will decrease the values with 0.1.
If TnumIO21 has got InputFormat ITexp, the value will be 0.00000E+00 at startup. Click Up button and then try to get back to 0.00000E+00 by clicking Up and Down buttons! Impossible! You'll always end up with a very, very small value!
The other TnumIO will show correct!

Any suggestions to a solution to this minor problem, only by clicking Up/Down buttons?

Karl Jan
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    www.sdlsuite.com Forum Index -> GuiPack All times are GMT + 1 Hour
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group